getting_started
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
getting_started [2021/11/17 12:34] – jason | getting_started [2021/11/17 14:02] (current) – jason | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | |||
- | |||
- | Visual Studio Code Template (debugging is a little sketch) | ||
- | |||
- | {{: | ||
Software Development: | Software Development: | ||
- | While not strictly required Visual Studio Code will be the official IDE used for software development. | + | [[Install Tools|Install Tools]] |
- | + | ||
- | [[https:// | + | |
- | + | ||
- | The next requirement is the SDK and tool chain for the Nordic NRF5340 processor running the watch. | + | |
- | + | ||
- | [[https:// | + | |
- | + | ||
- | Here is a good video tutorial on setting up the environment: | + | |
- | [[https:// | + | |
- | + | ||
- | FPGA Development: | + | |
- | + | ||
- | [[https:// | + | |
- | The FPGA development tools currently require a license which makes this inaccessible to many. A significant drawback to Efinix chips. | + | [[First Demo: Framebuffer|First Demo: Framebuffer]] |
- | Instillation: | ||
- | Follow the setup instructions for Visual Studio Code and the nRF connect SDK |
getting_started.1637170459.txt.gz · Last modified: 2021/11/17 12:34 by jason